Over 400+ Permanent Monitoring Systems Installed with a 98% Success Rate
DataCan’s permanent monitoring systems allow users to place pressure and temperature gauges in the wellbore and, using an armored mono-conductor cable, transmit downhole pressure data to the surface in real time. DataCan’s permanent monitoring systems use quartz or piezo sensor technology in a highly reliable, electron beam welded, hermetically sealed gauge. These gauges are held in place using a gauge carrier and gauge protector custom designed to suit the customer’s needs. DataCan provides high or low cost clamps and cabling solutions as well as CSA approved wellhead exits. DataCan’s surface box comes standard with a display and memory and an output signal allowing you to control pumps or valves. You can also transmit collected data via a cell phone or satellite modem right to your desk. DataCan systems are designed to run on 12V and a solar power cell can be supplied if required.
Permanent monitoring systems are growing in demand. The installation of a DataCan permanent monitoring system is very simple. This simplicity leads to higher system reliability. The simplicity also helps to lower costs, lower installation times, and fewer mistakes. DataCan’s permanent monitoring system is a very economical reservoir evaluation solution.
- Instant feedback on reservoir changes
- Quickly identify well problems
- Improve data clarity by reducing uncertainties
- Monitor skin, permeability, and pressure drawdown over time
- Evaluate operational efficiency
- Obtain initial build up data
- Identify reservoir connectivity
- Detect drainage or injection area changes
- Monitor well completion hardware (PCP and ESP optimization)
- No more well intervention surveys, resulting in lost production
- Automate your reservoir optimization solutions
- Monitor SAGD, and multi-zone completions
Reservoir Monitoring Data Acquisition
DataCan’s Surfaces Boxes are used to collect and store downhole data and can be used to control pumps or valves by sending a signal to the pump or valve controller. Surface boxes come standard with a display and memory, and have a 20 million sample capacity.
DataCan provides supplies welded and solid (non-welded) gauge carriers that are pressure testable and have a reliable metal to metal seal to prevent leaks from entering. Our permanent carriers have high burst and collapse pressures and can be configured to measure both internal (tubing) and external (annulus) pressures.
DataCan designs and manufactures a number of permanent downhole gauges to meet the needs of the customer. DataCan’s permanent downhole gauges are characterized by their fully welded construction, hermetically sealed electronics and dual protection metal to metal seal design.
Downhole permanent clamps are used to hold the conductor tube snug against the tubing string while protecting the conductor tube from any damage that may occur downhole. The clamps are installed on the collars, which is where they would most likely otherwise be pinched or damaged.
Splices are used in downhole permanent systems to join two conductor cables. The splices must provide a reliable electrical connection as well as a durable, leak resistant, mechanical connection.
Spooling Unit Hanger Feedthru Connector Spare Parts Permanent Pressure Test CAST - Protector Installation Kit
Every permanent monitoring system is custom built to suit the specific needs of each application. DataCan has engineered multiple solutions for each component of the permanent monitoring assembly.
Solar Powered Surface Data Collection
The Solar Powered Surface Data Collection allows the customer to run their permanent monitoring system when power is unavailable. Solar engine provides clean power; nice even voltage unlike a generator that can have fluctuating voltage.
DataCan’s Data2Desk system is used for permanent monitoring, diagnostic injection frac monitoring and off-set well monitoring. It allows the user to view well data in real time, from any location, using a secure web server.
Wellhead Outlet II
DataCan’s Wellhead Outlet II has a CSA explosion proof rating and is very quick and easy to install.
DataCan’s Cablehead is placed at the top of the toolstring and provides a mechanical and electrical connection between the tool string and wireline cable. The Cablehead has a simple yet reliable design that makes it quick and easy to install.